Xcommand Userinterface Presentation Externalsource Remove; Xcommand Userinterface Presentation Externalsource Removeall; Xcommand Userinterface Presentation Externalsource Select; Xcommand Userinterface Presentation Externalsource State Set - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand UserInterface Presentation ExternalSource Remove

Remove the input source (specified by the SourceIdentifier) from the list of external input
sources.
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Presentation ExternalSource Remove SourceIdentifier:
"SourceIdentifier"
where
SourceIdentifier: String (0, 40)
The unique string that identifies this input source. It was defined when the source was
created with the UserInterface Presentation ExternalSource Add command.

xCommand UserInterface Presentation ExternalSource RemoveAll

Remove all input sources from the list of external input sources.
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Presentation ExternalSource RemoveAll

xCommand UserInterface Presentation ExternalSource Select

Starts to present the input source (specified by the SourceIdentifier) if it is in Ready state (see
the UserInterface Presentation ExternalSource State Set command). The input source will be
shown in the user interface sharetray as "Presenting".
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL, USER
USAGE:
xCommand UserInterface Presentation ExternalSource Select SourceIdentifier:
"SourceIdentifier"
where
SourceIdentifier: String (0, 40)
The unique string that identifies this input source. It was defined when the source was
created with the UserInterface Presentation ExternalSource Add command.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xCommand xCommand

xCommand UserInterface Presentation ExternalSource State Set

Set or change the state of the input source (specified by the SourceIdentifier).
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Presentation ExternalSource State Set SourceIdentifier:
"SourceIdentifier" State: State
where
SourceIdentifier: String (0, 40)
The unique string that identifies this input source. It was defined when the source was
created with the UserInterface Presentation ExternalSource Add command.
State: Hidden/Ready/NotReady/Error
Ready: The input source will be presented when someone selects it (taps it on the user
interface, or when the UserInterface Presentation ExternalSource Select command is
issued).
NotReady: The input source is not ready, and cannot be selected.
Error: The input source is in an erroneous state. The ErrorReason parameter may be
used to inform the user about the reason for failure.
Hidden: The input source will not be displayed in the user interface sharetray.
ErrorReason: String (0, 80)
This string is displayed in the user interface sharetray, given that the State parameter is
set to Error.
161
API Reference Guide
xStatus Appendices
[ErrorReason: "ErrorReason"]
Copyright © 2017 Cisco Systems, Inc. All rights reserved.