Xconfiguration Video Selfview Default Onmonitorrole; Xconfiguration Video Selfview Default Pipposition - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Video Selfview Default OnMonitorRole

Define which monitor/output to display the main video source (self-view) on after a call. The
value reflects the monitor roles set for the different outputs in the Video Output Connector [n]
MonitorRole setting.
The setting applies both when self-view is displayed in full screen, and when it is displayed as
picture-in-picture (PiP), but only if the Video Monitors setting is set to Dual or Triple.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default OnMonitorRole:
where
OnMonitorRole
: Current/First/Second/Third
Current: When leaving a call, the self-view picture will be kept on the same output as it
was during the call.
First: The self-view picture will be shown on outputs with the Video Output Connector
[n] MonitorRole set to First.
Second: The self-view picture will be shown on outputs with the Video Output
Connector [n] MonitorRole set to Second.
Third: The self-view picture will be shown on outputs with the Video Output Connector
[n] MonitorRole set to Third.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
OnMonitorRole
xCommand

xConfiguration Video Selfview Default PIPPosition

Define the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video Selfview Default Mode
setting) and fullscreen view is switched off (see the Video Selfview Default FullscreenMode
setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default PIPPosition:
where
PIPPosition
: Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
106
API Reference Guide
xStatus Appendices
PIPPosition
Copyright © 2017 Cisco Systems, Inc. All rights reserved.