Standby Commands; Xcommand Standby Activate; Xcommand Standby Deactivate; Xcommand Standby Halfwake - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

Standby commands

xCommand Standby Activate

Set the system in standby mode, which turns off the video outputs and put the camera into
sleep mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Activate

xCommand Standby Deactivate

Bring the system out of standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Deactivate

xCommand Standby Halfwake

Sets the system to "Halfwake" state. This state informs the user from the UI, to pick up a
remote or to tap the touch device to get started.
Requires user role: ADMIN, INTEGRATOR
USAGE:
xCommand Standby Halfwake
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xCommand xCommand

xCommand Standby ResetTimer

Set a temporary standby delay. If the system is in standby mode when the reset timer is set,
the system is brought out of standby mode. When left idle for the given delay the system goes
into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid
standby delay.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby ResetTimer Delay:
where
Delay: Integer (1..480)
Set the delay in minutes.
151
API Reference Guide
xStatus Appendices
Delay
Copyright © 2017 Cisco Systems, Inc. All rights reserved.