Xcommand Video Matrix Assign; Xcommand Video Matrix Reset; Xcommand Video Matrix Swap; Xcommand Video Matrix Unassign - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand Video Matrix Assign

xCommand Video Matrix commands are a smart overlay to the xCommand Video Layout
commands to make it easy to do simple video compositions.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Matrix Assign [Mode: Mode] Output:
where
Mode: Add/Replace
Choose whether to replace the existing source on that output rendered full screen or to
add it. Using Add, the layout engine will recompose the multiple sources automatically.
Replace is the default value.
Output: Integer (1..3)
Choose the output you wish to use for this layout.
SourceId: Integer (1..4)
The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.

xCommand Video Matrix Reset

Reset the content on the output to the default layout
xCommand Video Matrix commands are a smart overlay to the xCommand Video Layout
commands to make it easy to do simple video compositions.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Matrix Reset [Output: Output]
where
Output: Integer (1..3)
Choose the output you want to reset.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
Output SourceId: SourceId
xCommand xCommand

xCommand Video Matrix Swap

Swap the content defined with xCommand Video Matrix Assign between two outputs.
xCommand Video Matrix commands are a smart overlay to the xCommand Video Layout
commands to make it easy to do simple video compositions.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Matrix Swap OutputA:
where
OutputA: Integer (1..3)
The output you are swapping from.
OutputB: Integer (1..3)
The output you are swapping to.

xCommand Video Matrix Unassign

Remove a source from an output. Just as with xCommand Video Matrix Assign the layout
engine will recompose the remaining sources automatically.
xCommand Video Matrix commands are a smart overlay to the xCommand Video Layout
commands to make it easy to do simple video compositions.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Matrix Unassign Output:
where
Output: Integer (1..3)
Choose the output you wish to remove the source from.
SourceId: Integer (1..4)
The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.
167
API Reference Guide
xStatus Appendices
OutputA OutputB: OutputB
Output SourceId: SourceId
Copyright © 2017 Cisco Systems, Inc. All rights reserved.