Xcommand Cameras Presentertrack Set; Xcommand Cameras Speakertrack Activate; Xcommand Cameras Speakertrack Deactivate - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand Cameras PresenterTrack Set

Set the presenter tracking mode.
This command takes effect only if the PresenterTrack feature is enabled. Sign in to the video
system's web interface and use the Cameras PresenterTrack Enabled setting to enable or
disable the feature.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Cameras PresenterTrack Set Mode:
where
Mode: Off/Follow/Diagnostic/Background/Setup/Persistent
Off: Turn off presenter tracking.
Follow: Turn on presenter tracking. This is the default mode when the feature is
activated from the Touch user interface. Presenter tracking is automatically turned off
when camera moves to a different preset, when another camera is selected, or when
standby is activated.
Diagnostic: Turn on diagnostic mode in order to troubleshoot presenter tracking, or
to see exactly what happens on the video system screen. In diagnostics mode there
are several activities on the screen. The screen will show the overview image, and the
rectangles/squares listed below will be visible:
* RED: The trigger zone.
* YELLOW: The cropped image of the presenter. Visible only when a face is being
tracked.
* GREEN: Indicates that a face is detected and that it is tracked.
* GREEN BLINKING FILLED: Indicates a positive face detection. If the tracked individual
does not get a valid face-read the square becomes red.
* RED BLINKING FILLED: Indicates a false face detection. After some seconds the
tracking stops.
* BLUE: A face is detected but the face is not tracked.
Background: This setting is used by the codec's internal scripts. Turns on presenter
tracking with no cropping of the image.
Setup: This setting is used by the codec's web interface to show the trigger zone on the
video system screen when setting up the PresenterTrack feature.
Persistent: This setting is used by the codec's internal scripts. Turns on presenter track-
ing in persistent mode. Persitent mode is automatically turned off when camera moves
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
Mode
xCommand xCommand
to a different preset.

xCommand Cameras SpeakerTrack Activate

Activate SpeakerTrack mode. Requires that xConfiguration Cameras SpeakerTrack Mode is set
to Auto (default).
This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera.
The SpeakerTrack 60 camera assembly consists of two cameras and uses an audio tracking
technique that finds and captures a close-up of the active speaker. When a change of speaker
is detected, the system can switch automatically between the two cameras to always show the
best camera view.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Activate

xCommand Cameras SpeakerTrack Deactivate

Deactivate SpeakerTrack mode.
This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera.
The SpeakerTrack 60 camera assembly consists of two cameras and uses an audio tracking
technique that finds and captures a close-up of the active speaker. When a change of speaker
is detected, the system can switch automatically between the two cameras to always show the
best camera view.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Deactivate
129
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.