Xcommand Camera Positionset; Xcommand Camera Preset Activate; Xcommand Camera Preset Activatedefaultposition - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand Camera PositionSet

Set the camera position.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera PositionSet CameraId:
Pan] [Tilt: Tilt] [Zoom: Zoom]
where
CameraId: Integer (1..7)
The ID of the camera preset you want to reset.
Focus: Integer (0..65535)
Focus the camera near or far.
Lens: Literal (Wide / Center / Left / Right)
Sets the camera's lens position.
Pan: Integer (-10000..10000)
Move the camera to the left or right.
Tilt: Integer (-2500..2500)
Move the camera up or down.
Zoom: Integer (0..8500)
Zoom in or out.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
CameraId [Focus: Focus] [Lens: Lens] [Pan:
xCommand xCommand

xCommand Camera Preset Activate

Activate one of the stored camera presets.
Note that the xCommand Camera Preset commands applies to an individual camera. This is
in contrast to the xCommand Preset commands where a single preset covers ALL connected
cameras plus the Video Input switcher settings.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera Preset Activate PresetId:
where
PresetId: Integer (1..35)
The ID of the camera preset you want to activate.

xCommand Camera Preset ActivateDefaultPosition

Sets the cameras to their default position, if one is defined. The default position is defined
by xCommand Camera Preset Store or by xCommand Camera Preset Edit. Only one default
position can be defined per camera.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera Preset ActivateDefaultPosition [CameraId: CameraId]
where
CameraId: Integer (1..7)
The ID of the camera preset you want to activate. If CameraId is not specified, all
cameras will be set in their respective default position, if one is defined.
124
API Reference Guide
xStatus Appendices
PresetId
Copyright © 2017 Cisco Systems, Inc. All rights reserved.