Userinterface Settings; Userinterface Accessibility Incomingcallnotification; Userinterface Branding Awakebranding Colors; Userinterface Contactinfo Type - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

UserInterface settings

UserInterface Accessibility IncomingCallNotification

You can enable an incoming call notification with amplified visuals. The screen and Touch
10 will flash red/white approximately once every second (1.75 Hz) to make it easier for
hearing impaired users to notice an incoming call. If the device is already in a call the screen
will not flash as this will disturb the on-going call, instead you will get a normal notification
on screen and touch panel.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Default
Value space: AmplifiedVisuals/Default
AmplifiedVisuals: Enable the amplified visuals on screen and touch panel when the
device receives a call.
Default: Enable the default behavior with a notification on screen and touch panel.

UserInterface Branding AwakeBranding Colors

If the device is set up with branding customizations, this setting affects the colors of the
logo that is shown when the device is awake. You can choose whether you want to show
the logo in full color, or reduce the opacity of the logo so that it blends in more naturally with
the background and other elements on the screen.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Native
Auto: The opacity of the logo is reduced.
Native: The logo has full colors.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration Peripherals Maintenance

UserInterface ContactInfo Type

Choose which type of contact information to show in the user interface.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/DisplayName/E164Alias/H320Number/H323Id/IPv4/IPv6/None/SipUri/
SystemName
Auto: Show the address which another device should dial to reach this video
conferencing device. The address depends on the default call protocol and device
registration.
None: Do not show any contact information.
IPv4: Show the device's IPv4 address.
IPv6: Show the device's IPv6 address.
H323Id: Show the device's H.323 ID (refer to the H323 H323Alias ID setting).
H320Number: Show the device's H.320 number as contact information (only supported
if used with Cisco TelePresence ISDN Link).
E164Alias: Show the device's H.323 E164 Alias as contact information (refer to the H323
H323Alias E164 setting).
SipUri: Show the device's SIP URI (refer to the SIP URI setting).
SystemName: Show the device's name (refer to the SystemUnit Name setting).
DisplayName: Show the device's display name (refer to the SIP DisplayName setting).

UserInterface CustomMessage

A custom message can be displayed, in the lower left side of the screen, in awake mode.
Requires user role: ADMIN, INTEGRATOR
Default value: ""
Value space: String (0, 128)
Add a custom message. Add an empty string to remove a custom message.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
162
Administrator Guide
Device settings Device settings Appendices