Camctrlpip Commands; Xcommand Camctrlpip; Camera Commands; Xcommand Camera Pantiltreset - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

CamCtrlPip commands

xCommand CamCtrlPip

Show or hide the camera self-view in a small window (picture in picture).
Mode: Select whether the self-view picture in picture is on or off.
Duration: Set how long the self-view is shown for on screen.
Requires user role: USER
Parameters:
Mode(r): <On/Off>
Duration: <0..60>
Example:
xCommand CamCtrlPip Mode: On Duration: 30
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration

Camera commands

xCommand Camera PanTiltReset

xCommand Camera PositionActivateFromPreset
xCommand Camera PositionReset
97
xCommand xCommand
The camera is reset to its default values for pan and tilt. If the camera is daisy chained, the
CameraId is given by its place in the chain.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
Example:
xCommand Camera PanTiltReset CameraId:1
Selects pan, tilt, zoom and focus parameters for the given camera id from the selected preset.
CameraId: Give the camera id.
PresetId: Select preset 1 to 15.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
PresetId(r): <1..15>
Example:
xCommand Camera PositionActivateFromPreset CameraId:1 PresetId:1
Reset the camera position the the default position.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
Example:
xCommand Camera PositionReset CameraId:1
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.