Directions for use
3. Attach Welch Allyn 3.5V instrument heads of your choice to the handles. See the
directions for use for each instrument head.
Set up the SureTemp® Plus thermometer
If your wall system is configured for a SureTemp Plus thermometer, follow these setup
instructions.
1. Align the probe well with the tabs facing up and down and insert the probe well into
the temperature module.
The probe well snaps into place when it is fully seated.
2. Hold the temperature probe cable connector with the spring tab on the right and
insert it into the probe port of the temperature module. Push it into place until it
clicks.
3. Insert the temperature probe into the probe well.
4. Open a box of probe covers and place it in the probe cover box holder.
Note
Spare boxes of probe covers can be stored in the
compartment on the top of the wall system.
Setup 51