Set Up The Suretemp® Plus Thermometer - Welch Allyn Connex Startup Manual

14 Setup
Set up the SureTemp® Plus thermometer
If your wall system is configured for a SureTemp Plus thermometer, follow these setup
instructions.
1. Align the probe well with the tabs facing up and down and insert the probe well into
the temperature module.
The probe well snaps into place when it is fully seated.
2. Hold the temperature probe cable connector with the spring tab on the right and
insert it into the probe port of the temperature module. Push it into place until it clicks.
3. Insert the temperature probe into the probe well.
4. Open a box of probe covers and place it in the probe cover box holder.
Note
Place spare boxes of probe covers in the storage compartment on the top of the
wall system.
Welch Allyn Connex® Integrated Wall System