Integrated Wall System; Supplies And Accessories; Unpack The Wall System - Welch Allyn Connex VSM 6000 series Directions For Use Manual

Directions for use

Integrated Wall System

Supplies and accessories

For a list of all approved supplies and accessories, see Approved Accessories in the
Appendices.

Unpack the wall system

This procedure applies to first-time setup of the wall system.
1. Lift the wall system out of the box by the cardboard handles.
2. With the wall system still in its packing material, place it onto a table or flat work
surface and remove it from the plastic bag.
3. Turn the wall system over so that back of the wall system faces up.
CAUTION Welch Allyn is not responsible for the integrity of any wall
mounting interface. Welch Allyn recommends that you contact your
Biomedical Engineering Department or maintenance service to ensure
professional installation, safety, and reliability of any mounting accessory.
CAUTION You must follow these instructions exactly to ensure safety and
ease of assembly.
CAUTION Do not remove any packing materials around the wall system
until the instructions tell you to do so.
Setup 41