Welch Allyn Connex VSM 6000 series Directions For Use Manual page 200

194 Advanced settings
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Pulse rate tab.
4. Specify settings.
Setting
Display source
5. Do one of the following:
•
•
Specify advanced etCO2 settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the etCO2 tab.
4. Specify settings.
Setting
Default view
Display FiCO2
Waveform scale default
Unit of measure
Check calibration
Calibrate
Sweep speed default
Enable sampling line dialog
BTPS compensation
Calibration due hours
Maintenance due hours
Last calibration
Annual calibration
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Welch Allyn Connex
Action/Description
Select this to show the source of pulse rate
measurements (NIBP or SpO2) on the Home tab.
Action/Description
Select a numeric view or a waveform view as the
primary etCO2 display on the Home tab.
Select to display FiCO2 on the Home tab.
Select the default waveform scale in etCO2
measurements.
Select primary units of measure for the etCO2 display on
the Home tab.
Select to start CO2 calibration check.
Select to start CO2 calibration.
Select the default waveform sweep speed for the CO2
waveform view on the Home tab.
Select to enable the sampling line dialog to be displayed
when connecting a sampling line to the device.
Select to enable automatic adjustments for BTPS (body
temperature pressure saturated) to improve the accuracy
of CO2 measurements.
Displays time remaining until CO2 sensor calibration is
required.
Displays time remaining until CO2 periodic sensor
maintenance is required.
Displays date (XX/XX/XXXX) and time (00:00:00) of last
calibration.
Displays anniversary date (XX/XX) of annual calibration.
®
Devices