36 Setup
1. Place your thumb and forefinger on the cable connector and squeeze the side tabs.
2. Align the cable connector with the cable connector port.
3. Insert the cable connector, pressing firmly until it clicks into place.
Connect the SpO2/RRa dual cable
Note
1. Connect the dual cable to the device as shown in the preceding steps. (The
connector is the same as for the standard SpO2 cable.)
2. Align the RRa dual cable connector and the RRa acoustic respiration sensor
connector so that the arrow labels point toward each other. Insert the RRa dual cable
connector into the RRa sensor connector until it locks into place.
3. Open the SpO2 dual cable connector's protective cover and align the arrow on this
connector with the arrow on the SpO2 sensor cable connector. Insert the SpO2
Monitors configured to measure acoustic respiration (RRa) require a dual
cable as shown below. The dual cable connects to the device with one
connector but splits into two separate cables at the other end to support
RRa and SpO2 measurement.
®
Welch Allyn Connex
Devices