Data Management - Welch Allyn Connex VSM 6000 series Directions For Use Manual

Directions for use
4. Select up to four parameters and associated units of measure for display in the
Manual Parameters frame.
Note
Note
5. Enable manual overrides of selected parameter measurements displayed on the
device as desired.
6. Do one of the following:
•
•

Data management

Specify patient settings
Patient identification appears on the Home tab in the Patient frame, and it is listed in
various tabs, such as the Patient tab and the Review tab.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
If the monitor has the SureTemp Plus temperature module,
the Temperature parameter is not available here or in the
Manual Parameters frame.
If the monitor is configured with CO2 or RRa, and you select
the Continuous Monitoring profile before you enter
Advanced settings, the respiration rate (RR) parameter is not
available here or in the Manual Parameters frame. If any
other profile is selected when you enter Advanced settings,
the respiration rate (RR) parameter remains available for
selection on this screen and is displayable in the Manual
parameters frame.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Advanced settings 199