Welch Allyn Connex VSM 6000 series Directions For Use Manual page 237

Directions for use
CO2 specifications (for additional information, refer to the directions for use that accompanies
each accessory)
Sampling rate
Calibration interval
Periodic service
etCO2
Units of measure
Display range
Resolution
Frequency response
FiCO2
Units of measure
Display range
Resolution
IPI
Display range
RR
Unit of measure
Display range
Accuracy
Resolution
1
For breath rates above 80 bpm, accuracy is 4 mmHg or ±12% of reading (whichever is greater) for etCO2 values
exceeding 18 mmHg when measured in accordance with ISO 80601-2-55.
Dispose of sampled gases according to facility requirements
or local regulations.
20 samples per second
Initial: After 1200 operating hours
Subsequent: After 4000 operating hours or annually
(whichever comes first)
After 30,000 operating hours
mmHg, kPa; user-selectable
0 to 150 mmHg (0.0 to 20.0 kPa)
1 mmHg, 0.1 kPa
The device maintains etCO2 accuracy up to 80 breaths/min.
From 81 to 150 bpm, accuracy is ±12%.
mmHg, kPa; user-selectable
0 to 150 mmHg (0.0 to 20.0 kPa)
1 mmHg, 0.1 kPa
1 to 10
breaths per minute
0 to 150 breaths per minute
0 to 70 breaths per minute: ±1 breath per minute
71 to 120 breaths per minute: ±2 breaths per minute
121 to 150 breaths per minute: ±3 breaths per minute
1 breath per minute
Specifications 231