Memory Control; Table 7- 5 Memory Control Menu - Siemens SITRANS FUP1010 Operating Instructions Manual

7.6

Memory Control

Introduction
Memory Control is a reference menu that shows the amount of bytes of data memory left.
The data memory capacity depends on the number and complexity of the site setups stored
in memory and the size of the current Datalogger file.
The [Memory Control] menu is located in the [Meter Facilities] menu.
Table 7- 5
Log Memory Left→
Memory Map→
Defragment→
Log Memory Left
This view only menu cell shows the minimum remaining number of characters available for
Datalogger and site storage. When the Datalogger is enabled for circular mode, the meter
allocates all memory left except for two conventional empty sites required for Datalogger
use.
To view the amount of data memory bytes available press <Right Arrow>.
Memory Map
Selecting [YES] for this item enables a snapshot display of current memory usage. In this
display, the asterisk indicates a used memory block, a space indicates a free block, while a
dash character indicates unused filler.
Defragment
Selecting [YES] for this item consolidates memory data blocks into contiguous storage;
collapsing the filler regions. You may be able to use an additional block for site or Datalogger
storage as a result. Use this command if you seem to be out of memory even though the
[Log Memory Left] item indicates free capacity.
FUP1010 IP67 Portable
Operating Instructions, 03/2012, A5E02951522-02
Memory Control Menu
XXXXXXX
No
Yes
No
Yes
Functions
7.6 Memory Control
91