Siemens SITRANS FUP1010 Operating Instructions Manual page 40

Connecting
5.2 Sensor Wiring
4. Pre-programmed Pipe Size and relevant pipe parameters will appear in menu cells. Press
Note
The DN sizes listed in the [Select Pipe Size] menu option list are referenced to DIN Table
2448. After selecting pipe size, check pipe OD and wall thickness for correct dimensions.
5. Press the <Left Arrow> and return to the main menu.
Select a Liquid Class
1. Press the <Down Arrow> and scroll to [Application Data].
2. Press the <Right Arrow> to select [Liquid Class].
3. Press the <Right Arrow> again and scroll to desired liquid.
4. Press <ENTER> to save selection.
Select Pipe Configuration
1. Scroll down to [Pipe Config] and press the <Right Arrow>.
2. Select a configuration that approximates the conditions upstream of your sensor
3. Press <ENTER> to save selection.
38
<Right Arrow> and scroll to desired pipe size. Press <ENTER>. Enter dimensions
manually if pre-programmed dimensions do not match application.
①
Select from list.
mounting location. (Refer to the definitions below.)
FUP1010 IP67 Portable
Operating Instructions, 03/2012, A5E02951522-02