Siemens SITRANS FUP1010 Operating Instructions Manual page 56

Connecting
5.2 Sensor Wiring
Installing a 1012T Mounting Track in Direct Mode
The Sensor Installation procedures show how the automatic selection of sensors, mounting
mode and spacing method are established. Examine the figure below, which illustrates a
typical [Install Sensor] menu screen. Note the automatic assignment of model numbers for
the sensor and mounting track, plus the designation of the Number Index.
①
The combination of two Model 1012TP Mounting Tracks and a spacer guide is the
recommended way to mount sensors in the Direct Mode. This method ensures that sensors
will align exactly 180° from each other and remain spaced the proper distance apart.
The Direct Mount configuration uses a set of two track rail assemblies; one for each sensor,
installed 180° apart on the pipe. The set includes:
● Direct Mode Track Assembly - This track rail has number index holes for inserting an
54
Automatic selection of mounting track part number , mount mode and Number Index
index pin to position the other sensor.
FUP1010 IP67 Portable
Operating Instructions, 03/2012, A5E02951522-02