Connecting
5.2 Sensor Wiring
4. Attach the EZ Clamp to the sensor under the spring clip. The adjusting nut knob should
Note
To surround larger pipes, link multiple lengths of chain together by mating the Bit Snap
and "S" hook.
5. Take sensor and apply a continuous lengthwise 3 mm (1/8-inch) bead of coupling
46
be pointing up and on the side opposite of the spacer bar. Unscrew the knob until it's at
the stop.
①
Adjusting Nut
②
Bit Snap
③
Sensor
Figure 5-16
EZ Clamping Sensor to Pipe
①
Mate Bit Snap and "S" Hook to extend chain
Figure 5-17
E-Z Clamp S-Hook
compound across the center of the sensor emitting surface.
①
Cable Connector
②
Angled Edge
③
Sensor
Figure 5-18
Sensor
④
E-Z Clamp Chain
⑤
Pipe
④
Front Edge
⑤
Emitting Surface
⑥
Coupling Compound
Operating Instructions, 03/2012, A5E02951522-02
FUP1010 IP67 Portable