Site Setup For Sitrans F - Siemens SITRANS FUP1010 Operating Instructions Manual

A.3

Site Setup For SITRANS F

How to use the Windows HyperTerminal Program
Windows provides a communication program called HyperTerminal, which is ideal for
interfacing your computer with the flow meter. The following typical example explains how to
set up HyperTerminal.
Note
Depending upon the Windows applications being used this setup procedure may vary.
1. From the Windows desktop, left-click on the [START] button.
2. Holding down the left mouse button, move the highlight up to [Programs], then across to
3. Within the HyperTerminal window, move the mouse pointer down to [Hyperterm.exe] and
4. This selects the [Connection Description] dialog box. Enter a name for your connection
5. This selects the [Phone Number] dialog box. Move the cursor to the arrow at the right of
6. You will now see a blank terminal screen. Next left-click [File] on the top menu bar. Drag
FUP1010 IP67 Portable
Operating Instructions, 03/2012, A5E02951522-02
[Accessories] then [Communications]. Slide the highlight down to [HyperTerminal], then
release the left mouse button.
then double-click the left mouse button.
(e.g., 1010N). You can optionally select an icon for this connection by clicking on one of
the icons displayed in the scrolling frame at the bottom of the window. Click [OK].
the [Connect Using] field. Left click on the arrow to expand the field and then move the
highlight down to [Direct to Com 1 (or 2)] depending on the port connected to the
interface cable. Click [OK] to select the [Com 1 (or 2) Properties] Dialog box. Set up your
RS-232 parameters as shown in the example below. Left-click on the [OK] button.
the highlight down to [Properties] and then left-click.
Appendix
A.3 Site Setup For SITRANS F
145