5. Take sensor and apply a continuous lengthwise 3 mm (1/8-inch) bead of coupling
6. Place sensor at the center of the pipe in the middle of one of the areas you have cleaned.
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
①
Adjusting Nut
②
Bit Snap
③
Sensor
Figure 5-14
EZ Clamping Sensor to Pipe
Note
To surround larger pipes, link multiple lengths of chain together by mating the Bit Snap
and "S" hook.
①
Mate Bit Snap and "S" Hook to extend chain
Figure 5-15
E-Z Clamp S-Hook
compound across the center of the sensor emitting surface.
①
Cable Connector
②
Angled Edge
③
Sensor
Figure 5-16
Sensor
Ensure that the cable connector is facing away from where the other sensor will be placed.
④
E-Z Clamp Chain
⑤
Pipe
④
Front Edge
⑤
Emitting Surface
⑥
Coupling Compound
Connecting
5.2 Sensor Wiring
43