Table of Contents
Advertisement
This screen contains MAC Address, System Name, IP Address, Uptime, and System Description (comprises of device
description, firmware version, serial number, and bootloader version).
5. Click Select Adapter, to change adapter settings.
6. From the list, identify and select the MAC address of the device that needs to be initialized, and click Web Config to
log on to the Graphical User Interface.
: If the device does not appear in the Scan List, click Rescan in the Scan List screen. If the device still does not appear
in the list, see Troubleshooting. Note that after rebooting the device, it may take up to five minutes for the device to
appear in the Scan List.
6.1.2 Modifying the IP Address of the Device using ScanTool
To modify the IP address of a device using ScanTool, select the device from the scan list and click Change. A Change screen
appears as shown in the following figure.
The system automatically populates the MAC Address, System Name, TFTP Server IP Address and Image File Name of
the device.
Assigning the IP Address
1. Select the IP Address Type as static/dynamic for IPv4 and as static/dynamic/auto for IPv6.
•
Static: When set to static, the IP Address, Subnet Mask, and the Gateway IP Address of the device can be
manually changed.
•
Dynamic: When set to dynamic, the IP Address, Subnet Mask, and the Gateway IP Address is dynamically
generated by the DHCP server.
•
Auto: When set to auto, the IPv6 address is calculated by the device using the router advertisement messages.
2. Enter the SNMP Read/Write password in the Read/Write Password box. By default, it is public.
3. Click OK to save the details. The device automatically reboots.
To log on to the Graphical User Interface, click Web Configuration. For details, refer
Device Management Guide
Figure 6-3 Modifying Device IP Address (IPv4 and IPv6)
Logging
In.
Tools
41
Advertisement
Table of Contents
