Emergency Opening - CEStronics OMEGA ACTIVE IES Fitting And Operating Instructions

11

Emergency opening

If the battery is empty, you can connect an Emergency Power
Supply with the IES to provide the required voltage. To open
the door, you also require an authorized locking medium to
confirm that you have authorized access.
The Emergency Power Supply is not part of the
scope of delivery of the IES. To order it, please

contact your CEStronics partner.

After an emergency opening, the IES is no
longer secured. In this case, you can no
longer lock the IES from the outside. You can
only lock the IES again after you have inserted
a new battery.
Always insert new batteries into the battery

compartment of the electronics module after an
emergency opening.
The interface for the Emergency Power Supply is in the reader
unit of the outside shield. To perform the opening with the
Emergency Power Supply, proceed as follows:
1.
Fig. 139 – Insert the phonoplug
OMEGA ACTIVE IES
NOTICE
Emergency opening
Insert the phonoplug

(1) into the socket
next to the On/Off
switch on the back of
the Emergency Power
Supply.
Ensure that the

Emergency Power
Supply is switched
off.
Page 103 of 128