Table of Contents
Advertisement
19.
Fig. 116 - Mount the base plate
20.
Fig. 117 - Mount the crossbar
mechanism
21.
Fig. 118 - Fit the covers
OMEGA ACTIVE IES
Apply the base plate.
Carefully guide the
cable through the slit
underneath the
fastening screw.
Screw the base plate to
the door.
Depending on door
design, use a wooden
or sheet metal screw as
lowest screw.
Tighten the two M5
fastening screws (1).
Screw the crossbar
mechanism onto the
base plate.
To this end please use
the M4 × 6 mm screws
(at the top) and two
M5 × 6 mm (in the
middle/at the bottom).
Fit both covers to the
crossbar mechanisms.
Use the stud screws to
fasten them both from
underneath.
Page 85 of 128
Fitting
Advertisement
Table of Contents
