CEStronics OMEGA ACTIVE IES Fitting And Operating Instructions page 72

Fitting
19.
Fig. 88 - Fasten the inside shield
20.
Fig. 89 - Guide the cable

NOTICE
If the ESD cover (3) is removed, this may
cause malfunctions of and/or damage to
the IES.
Do not remove the ESD cover of the electronic

unit (3).
Page 72 of 128
Push the inside plate

with the electronics
module onto the
square.
Fasten the inside

shield with the two
M5 x 6 mm fastening
screws.
Be sure not to

squeeze or damage
the cable.
Guide the cable (1)

below the holder of
the inside handle
upward to the plug
connector.
Be sure not to

damage or squeeze
the cable.
OMEGA ACTIVE IES