Table of Contents
Advertisement
Fitting
11.
Fig. 108 - Drill the marked holes
12.
Fig. 109 - Fit the lock
13.
Fig. 110 – Insert the locking
cylinder
Page 82 of 128
Drill the marked holes
for the fixing screws
with a power drill.
Drill from both sides
so that the drill does
not run off centre.
Remove all chips.
If the lock had been
removed, fit it again.
Optional fitting step:
Insert the locking
cylinder into the lock.
Fix the locking
cylinder loosely with
the cylinder fixing
screw so as to just
prevent slipping.
Do not yet tighten the
cylinder fixing screw
at this point.
OMEGA ACTIVE IES
Advertisement
Table of Contents
