Access In Emergency Situations (Emergency Mode) - CEStronics CES OMEGA FLEX Assembly And Operating Manual

5.3 Access in emergency situations (emergency mode)

5.3.1 Activating emergency mode
Emergency mode is similar to release mode: the locking device remains constantly coupled so that the door
can be opened at any time without having to use a locking medium.
Unlike release mode, however, emergency mode cannot be cancelled again by the Release-Master but only
by the Emergency-Key and has the highest priority of all the opening modes, see
modes" on page 38.
Required:
Emergency-Key (must be authorised for the locking device beforehand)
l
Procedure:
Steps
1. Hold the Emergency-Key in the reading field of the locking device for approx. 1 second.
The Emergency-Key is read and accepted.
2. Remove the Emergency-Key from the reading field of the locking device.
The locking device is now in emergency mode. Access is now permanently possible without
the locking media since the locking device remains permanently uncoupled. Emergency
mode can only be deactivated again by an Emergency-Key.
Troubleshooting:
Signal
1x long red
Wide shield replacement handle set ILS-I
5.3 Access in emergency situations (emergency mode)
Cause
The Emergency-Key could be read but is not authorised for this
locking device.
"Hierarchy of opening
Signal
1x short green
Solution
Authorise the
Emergency-Key.
Page 17 of 83