Table of Contents
Advertisement
18.
Fig. 34 - Secure the inside plate
19.
Fig. 35 - Plug in the plug
connector
If the ESD cover (3) is removed, this may
cause malfunctions of and/or damage to the
IES.
Do not remove the ESD cover of the electronic
unit (3).
OMEGA ACTIVE IES
NOTICE
Secure the inside
plate with the two
M5 × 60 mm fixing
screws to the outside
shield.
Tighten the two
fixing screws with a
tightening torque of
2.5 ± 0.5 Nm.
Carefully plug in the
plug connector of the
12-conductor cable
(1).
Carefully plug in the
plug connector of the
antenna (2).
Make sure that no
contacts are bent in
the process.
Page 49 of 128
Fitting
Advertisement
Table of Contents
