Table of Contents
Advertisement
6.1.1
Unpacking the IES
Take the IES from the package and remove all packaging
material such as films, padding and packaging board.
Also remove the piece of cardboard which is placed
between the shield and the electronics module in the inside
shield.
Take care that you do not accidentally discard the
enclosed drilling template as well.
Fig. 7/8 - Preparing the IES
The door may accidentally close while your
are fitting the IES and it may not be possible
to open the door again.
OMEGA ACTIVE IES
NOTICE
Secure the door against accidental closing
when fitting the IES.
Ensure that you have an authorized locking
medium ready.
Carefully lift the inside
shield from the inside
plate.
Make sure that the
distance piece for the
screw remains fixed in the
inside shield.
Remove your existing door
fitting.
Fitting
Page 33 of 128
Advertisement
Table of Contents
