Table of Contents
Advertisement
Fitting
11.
Fig. 27 - Drill the marked holes
12.
Fig. 28 - Insert the lock
13.
Fig. 29 - Insert the locking
cylinder
Page 46 of 128
Drill the marked
holes for the fixing
screws with a power
drill.
Drill from both sides
so that the drill does
not run off centre.
Remove all chips.
Insert the lock again.
Optional fitting step:
Insert the locking
cylinder into the
lock.
Fix the locking
cylinder loosely with
the cylinder fixing
screw so as to just
prevent slipping.
Do not yet tighten
the cylinder fixing
screw at this point.
OMEGA ACTIVE IES
Advertisement
Table of Contents
