Table of Contents
Advertisement
Fitting
Malfunctions may occur if the connection
cable is squeezed!
19.
Fig. 60 - Guide the cable
20.
Fig. 61 - Fasten the inside shield
Page 60 of 128
NOTICE
Be sure that the connection cable is guided
through the escutcheon hole without being
damaged.
Be sure that the connection cable is not
squeezed when you mount the outside shield.
Guide the
connecting cables
through the cut-out
of the inside plate
with the electronics
module as shown in
the figure.
Be sure not to
damage or squeeze
the cable.
Push the inside plate
with the electronics
module onto the
square.
Fasten the inside
shield with the two
M5 x 6 mm
fastening screws.
Be sure not to
squeeze or damage
the cable.
OMEGA ACTIVE IES
Advertisement
Table of Contents
