Table of Contents
Advertisement
Fitting
6.
Fig. 22 - Insert the silicone
bearings
NOTICE
Malfunctions may occur if the coupling unit is not
fitted properly and/or the tabs are bent!
Be sure that the tabs are not bend.
Be sure that the coupling unit is placed firmly and
flush in the outside shield.
Be sure that both silicone bearings are fitted
properly.
7.
Fig. 23 - Fasten the handle screw
Page 44 of 128
Now insert the
bottom end of the
coupling unit into
the outside shield.
Use a suitable
screwdriver to
position the bottom
silicone bearing into
the tab.
Fasten the hexagon
socket head screw of
the handle of the
outside shield using
the 3 mm hexagon
socket head key.
Push the centring
sleeve onto the
lower tapped bush.
OMEGA ACTIVE IES
Advertisement
Table of Contents
