Table of Contents
Advertisement
up! 2012 ➤
Electrical system - Edition 03.2017
– Undo and remove bolt -1- and remove clamping plate -2-.
– Remove battery -4-.
Installing
Caution
A loosely fitted battery creates the following dangers:
♦ Shortened service life caused by vibration damage (dan‐
ger of explosion).
♦ Damage to the grid plates of the battery.
♦ Damage to battery casing by clamping bracket (possible
leakage of acid with high consequential costs).
♦ Poor crash safety.
Install in the reverse order of removal, observing the following:
– Place battery -4- on battery tray -3- and push towards rear.
– Put clamping plate -2- on and secure with bolt -1-.
– Check battery is firmly seated after installation.
– Connect battery
⇒ page 5
Note
In vehicles with a battery sensor (start-stop system), the bat‐
♦
tery has to be parameterised after a new starter battery has
been installed.
The battery parameterisation sends the technical data of the
♦
new battery to the battery monitor.
Performing battery parameterisation
♦
Specified torques
♦
⇒ "1.1 Assembly overview - battery", page 1
1.3
Removing and installing earth wire with
battery monitor control unit - J367-
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
4
Rep. gr.27 - Starter, current supply, CCS
.
⇒ page 5
.
Advertisement
Table of Contents
