High Speed Flow Control Configuration Screen - Nortel 2000 Using Manual

204 Chapter 3 Using the console interface
Table 29 Port Configuration screen fields (continued)
Field
Speed/Duplex
1
1 Fiber optic ports can only be set to 100 Mb/s/Half or 100 Mb/s Full.

High Speed Flow Control Configuration screen

The High Speed Flow Control Configuration screen
the port parameters for installed Gigabit MDAs.
➨
Choose High Speed Flow Control Configuration (or press h) from the Switch
Configuration Menu screen to open the High Speed Flow Control
Configuration screen.
208700-B
Description
Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s
or 100 Mb/s, in half- or full-duplex mode. This field is set (by default) to 1000 Mb/s,
full-duplex for Gigabit ports only.
Default Value 100Mbs/Half (when Autonegotiation is Disabled)
Range 10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full
Note: This screen only appears when an optional Gigabit MDA is
installed in the Uplink Module slot.
(Figure 73) allows you to set