Default Qos Egressmap Command; Qos Ingressmap Command; Default Qos Ingress Command; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

52 Chapter 2 Configuring Quality of Service (QoS) with the CLI

default qos egressmap command

The default qos egressmap command resets the egress mapping
entries to factory default values.
The syntax for the default qos egressmap command is
default qos egressmap
The default qos egressmap command is executed in the Global
Configuration command mode.

qos ingressmap command

The qos ingressmap command configures 802.1p priority-to-DSCP
associations that are used for assigning default values at packet ingress
based on the 802.1p value in the ingressing packet.
The syntax for the qos ingressmap command is
qos ingressmap [name
"qos ingressmap parameters" (page 52)
command.
qos ingressmap parameters
Parameter
name <WORD>
1p <0-7>
ds <0-63>
The qos ingressmap command is executed in the Global Configuration
command mode.

default qos ingress command

The default qos ingressmap command resets the ingress mapping
entries to factory default values.
The syntax for the default qos ingressmap command is
default qos ingressmap
The default qos ingressmap command is executed in the Global
Configuration command mode.
Copyright © 2007, Nortel Networks
.
<WORD>] 1p
Description
Specify the label for the ingress mapping.
Enter the 802.1p priority used as lookup key for DSCP
assignment at ingress; range is between 0 and 7.
Enter the DSCP value associated with the target 802.1p
priority; range is between 0 and 63.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
<0-7> ds
outlines the parameters for this
03.01 Standard
<0-63>