No Qos Acl-Assign Command; Qos Ip-Acl Command; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

This command is executed in the Global Configuration command mode.

no qos acl-assign command

The no qos acl-assign command removes an access list assignment.
The no qos acl-assign <aclassignid> enable command disables
an access list assignment.
The syntax for this command is
no qos acl-assign
Substitute <aclassignid> above with the unique identifier of the access
list assignment to remove or disable.
Run the no qos acl-assign command in Global Configuration command
mode.

qos ip-acl command

The qos ip-acl command creates an IP access list.
The syntax for this command is
qos ip-acl
src-port-max <port>]
dst-port-max <port>]
"qos ip-acl parameters" (page 45)
qos ip-acl parameters
Parameter
name <name>
addr-type <addrtype>
Copyright © 2007, Nortel Networks
.
<aclassignid> enable
name <name>
[addr-type <addrtype>]
[src-ip <source_ip>]
[dst-ip <destination_ip>]
[ds-field <dscp>]
[{protocol <protocol_type> | next_header
<header>}]
[src-port-min <port>
[dst-port-min <port>
[session-id <sessionid>]
[drop-action {enable | disable}]
[update-dscp <0 - 63>]
[update-1p <0 - 7>]
[set-drop-prec {high drop | low drop}]
[block <block_name>]
Description
The name assigned to this access list.
The IP address type to use for the access list; range
is ipv4 or ipv6.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
Configuring QoS Access Lists 45
outlines the parameters for this command.
03.01 Standard