Configuring An Enable Password - Nortel 2350 Installation And Basic Configuration Manual

82 Configuring a 2370, 2360, or 2380 Switch for Basic Service
Figure 21. Example Nortel Network
serial-id 0322199997
AP-2330
Port
1
WSS1
System IP address
10.10.10.4
Port
3
Wired
authentication
client
VLANs on WSS1
VLAN 2 mgmt, port 5, 10.10.10.4/24
VLAN 4 blue, port 5, tag 20, 10.10.20.2/24
VLAN 3 red, port 5, tag 30

Configuring an Enable Password

WSS Software does not require you to change the enable password from the default (null string). However,
Nortel recommends that you configure an enable password to provide at least minimal security to the WSS
before you proceed to more advanced configuration options.
To configure an enable password, use the following command:
set enablepass
To configure an enable password:
1
If you are not already at the enabled access level, enter the enable command.
2370> enable
2
At the enabled prompt, enter set enablepass.
2370# set enablepass
320656-A
serial-id 0322199996
AP-2330
Port
2
Port
5
Port
4
AP-2330
serial-id 0322199995
WSS2
serial-id 0322199999
AP-2330
System IP address
10.10.40.4
10.10.40.19/24
10.10.20.19/24
Layer 2
10.10.30.19/24
10.10.60.19/24
10.10.10.19/24
10.10.60.18/24
10.10.50.19/24
WMS
WSS3
System IP address
10.10.50.4
RADIUS
servers
10.10.70.20
Router
10.10.70.40
Layer 2
AP-2330
serial-id 0322199998
Router
Layer 2