Ip Ipfix Collector Command; Ip Ipfix Enable Command (Global Configuration); Nortel Ethernet Routing Switch 5500 Series; Nn47200-505 03.01 Standard - Nortel 5510 Configuration

ip ipfix collector command
The ip ipfix collector command is used to configure IPFIX
collectors. IPFIX collectors are used to collect and analyze data exported
from an IPFIX compliant switch. In Software Release 5.0, the only external
collector supported is NetQOS. At this time, up to two collectors can be
supported.
IPFIX data is exported from the switch in Netflow version 9 format. Data
is exported using UDP port 9995.
The syntax of the ip ipfix collector command is:
ip ipfix collector <unit_number> <collector_ip_address>
[dest-port <destination_port>] [enable] [exporter-ip
<exporter_ip_address>]
The following table describes the parameters for this command.
ip ipfix collector Parameters
Parameter
<unit_number>
<collector_ip_address>
<destination_port> The port on which the collector will be listening for IPFIX
<exporter_ip_address>
The ip ipfix collector command is executed in the Global
Configuration mode.
ip ipfix enable command (Global Configuration)
The ip ipfix enable command is used to globally enable IPFIX on
the switch.
The syntax of the ip ipfix enable command is:
ip ipfix enable
The ip ipfix enable command is executed in the Global Configuration
mode.
Copyright © 2005 - 2007, Nortel Networks
.
IPFIX Configuration using the Command Line Interface 127
Note: IPFIX data is not load balanced when two collectors are in use.
Identical information is sent to both collectors.
Description
The unit number of the collector. Currently up to two
collectors are supported so the values 1 or 2 are valid.
The IP address of the collector.
data. Currently only port 9995 is supported for this task.
The IP address of the IPFIX exporter.

Nortel Ethernet Routing Switch 5500 Series

Configuration - System Monitoring

NN47200-505 03.01 Standard

5.1 27 August 2007