Unpacking - Symmetricom TimeSource 3600 User Manual

Chapter 3 Installing the TimeSource 3600

Unpacking

Unpacking
Use the procedures in the order they appear in this chapter to install the
TimeSource 3600. If any difficulties are encountered during the installation process,
contact Symmetricom's Customer Technical Assistance Center (CTAC). Refer to the
Technical Assistance section of the Troubleshooting chapter for telephone numbers.
CTAC includes Product Technical Support for technical information, and Customer
Service for information about an order, RMAs, and other information.
ESD Caution: To avoid damage from electrostatic discharge (ESD),
when handling electronic equipment, use local office procedures,
including:
Note: Save packing material. All equipment returned must be packed
in the original packing material. Contact Customer Service if
additional packaging is needed.
Unpack equipment carefully; check for completeness against the purchase order.
Notify Symmetricom if items are missing.
Inspect equipment for shipping damage, including bent or loose hardware, and
broken connectors.
If equipment was damaged in transit, contact Customer Service to request an RMA,
and notify the carrier.
Installing the Antenna
Installing a Roof Antenna
Installation procedures are to follow local company procedures and the Installation
Job Specification.
Prior to installing the antenna, the site, antenna location, lightning suppressor
location, lightning suppressor grounding point, cable route, and all other details
should have been planned.
58 TimeSource 3600 User's Guide
Use grounded wrist straps connected to equipment frame ground
when handling cards.
Store cards only in antistatic packaging provided by the factory
097-72060-01 Revision J – June, 2007