Front Panel Items - Symmetricom TimeSource 3600 User Manual

Table 5-1. Front Panel Items
Name State
Status GPS Off
Green
Yellow
Red
Status SYS Off
Green
Red
Alarms CRIT Off
Red
Alarms MAJ Off
Red
097-72060-01 Revision J – June, 2007
Description
System is not powered.
GPS is successfully tracking
satellites, or is in warm-up.
A GPS event has occurred.
A GPS event, which has existed
per the user alarm setting, has
escalated to a minor alarm.
System is in warm-up mode or is
not powered.
The output signal is PRS.
The system has been in
holdover per the user alarm
setting, or there is a hardware
fault.
There is no critical alarm.
A critical alarm has occurred
because of a hardware failure.
There is no major alarm.
The system has been in
holdover per the user alarm
setting.
Chapter 5 Troubleshooting
Troubleshooting with Front Panel Items
Action
If in warm-up, none required.If there
is no power, apply power.
None required.
None required.
Refer to Table 5-2 to determine
which type and combination of
antenna alarms exist, and the
recommended action.
If in warm-up, none required. If there
is no power, apply power.
None required.
Refer to Table 5-2 to determine
which type and combination of
alarms exist, and the recommended
action.
None required.
Replace the plug-in card using
Procedure 5-1
.
None required.
Refer to Table 5-2 to determine
which type and combination of
antenna alarms exist, and the
recommended action.
TimeSource 3600 User's Guide 185