Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
3.6.3 802.1Q VLAN Membership Configuration
The 802.1Q VLAN Membership tab defines the VLAN IDs (VIDs) and the port membership for each of
the VLANs. For practical reasons, only up to 64 VLANs may be defined in the IS-2, with VIDs ranging
from 1 to 4095.
Before a VLAN can be used on the switch, its ID must first be defined in the VID list below, then all ports
that will participate in this VLAN will be checked against this VID. For an access port, only one VID
should be associated with a given port, for a trunk port, all VLANs carried over the trunk should be
associated with the trunk port.
Figure 3-22 Features menu, 802.1q VLAN Membership tab
To configure VLAN membership
1. Click on the Features icon and select from the Features menu the VLAN Mode
tab, Select 802.1q VLAN Enabled.
2. From the 802.1Q VLAN Membership tab, click Add. A prompt appears,
requesting a New VLAN ID number. Enter a number that is not currently used
by an existing VLAN, then click OK.
3. Now that the new VLAN appears on the 802.1Q VLAN Membership tab, check
all the ports to be included in the VLAN and click Apply.
To delete a VLAN:
• Select that VLAN from the list in the 802.1Q VLAN Membership tab and click
Delete. The VLAN is deleted without verification.
To edit a VLAN:
• Click on the ports to edit, set the required changes and click Apply.
SUMMARY
Page 38 of 87
Advertisement
Table of Contents
