Restoring Manageable Mosaic Switch Factory Default Settings - LEGRAND Mosaic Manageable switch Installation And Configuration Manual

Manageable Mosaic switch Installation and User Guide
3. The new factory defaults will be activated after the next Restore Factory Default
command.

4.3.3 Restoring manageable Mosaic switch Factory Default Settings

1. Log in to the LCS
2. From the LCS
Factory Defaults. The following prompt is displayed.
Figure 4-9 Restoring Factory Defaults via Embedded web interface
3. Click Yes to restore the device's factory defaults.
4.3.4 Configuring Active Management Interfaces
Factory defaults configure all three management interfaces (SNMP, Web and Telnet) to be active. This
configuration can be changed for the device to be only managed by one or a combination of two
management interfaces
To configure the management interfaces proceed as follows:
1. From the Embedded web interface main screen, click System Config. The System
Configuration window appears.
2. Click the Config tab of the System Configuration window. The following screen is
displayed.
2
- FTTO Init application.
2
- FTTO Init application menu, click Commands, and choose Restore
SUMMARY
Page 55 of 87