Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
8 8 T e l n e t
T e l n e t
8.1
General
Telnet enables remote management of a single IS-2 unit as well as remote configuration of any number
of units by running Telnet script files created for that purpose.
8.2
Run Telnet
1. From the PC Start menu, type Run Telnet followed by a space and then the IP
address of the target device (exact syntax according to the operating system).
or
From a telnet client application, connect using telnet protocol to the IP address
of the target device (Note: when using PuTTY, the password can be rejected
even if entered correctly. In that case, please make sure to make the following
change in PuTTY configuration ➨ Terminal :
Local Echo: Off and Local line editing Off).
2. At the prompt, enter the current password (mypass is the factory default); the
password is case sensitive. If the password is rejected, please see the specific
note for PuTTY in 6.2, 1).
The device prompt, '>' appears. The device is ready to receive Telnet
commands (see Figure 8-1).
Note: The Telnet password can only be changed through the local CLI (serial)
connection.
8.2.1 Invoking Telnet Help
To view the list of available commands, type ? or help and press Enter.
•
To invoke help on a specific command, type the command, followed by a space and ?
•
Figure 8-1 illustrates the list of available Telnet commands. Figure 8-2 illustrates an example of help on
specific command
SUMMARY
Page 82 of 87
Advertisement
Table of Contents
