Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
5.1.1 Community String / Passwords
The community string is part of the SNMP packet. The SNMP agent will not respond to SNMP packets
whose community string does not match its internal community string. The community string is an
alphanumeric string of up to 15 alphanumeric characters.
SNMP defines different community strings for Get and Set commands. The factory default community
settings of the device are:
SNMP Get community – public SNMP Set community – private
These community strings may be modified through the CLI or via the Telnet commands: set get
community and set set community (see Section 8).
5.1.2 User Access Levels
The manageable Mosaic switch defines three user access levels: Guest, Administrator and
Technician. For details, see Section 3.1.1 and Section 3.1.2.
5.1.3 Management Access List
The management access list restricts management access only to managers whose IP address is listed
in the device Access List. Up to eight entries can be defined.
When the access list is enabled, the device may be reached only by remote manager(s) whose IP
address is listed in the access list. When the access list is disabled, the device may be reached from
any IP address.
NOTES
The access list may also be managed through Telnet "show/add/delete acl entry"
command (see Section 8).
The access list security cannot be enabled unless the IP address of the active manager
exists on the list.
The IP address of the active manager cannot be deleted as long as the Enable access list
is check-marked.
To define the Management Access List:
1. From the Embedded web interface main screen, click Management and expand the
Access List tab.
SUMMARY
Page 58 of 87
Advertisement
Table of Contents
