Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
NOTE: It is not recommended to change the default voltage thresholds. Threshold alerts
are only generated when the limits are crossed.
To change the Temperature or Voltage limits:
1. Enter the Management application at a Technician level.
2. Click on the System icon and select the from the System View menu the Environment
tab.
3. Click Thresholds bar at the Environment tab.
Figure 3-16 Thresholds window
4. In the Thresholds window, enter the new Temperature and/or Voltage thresholds and
click OK. Allowed values are:
•
•
•
3.5.5 Factory Defaults
Figure 3-17 System View menu, Factory Defaults tab
The unit default parameters can be restored at any time.
NOTE: This can also be done through Telnet (see Section 8) and LCS
Restoring the factory default settings will not affect the IP configurations or the Get / Set
Community settings.
To reload the unit default parameters (from a Technician or Administrator level only):
1. Click on the System icon and select the Factory Defaults tab
2. Select desired values for User port status (On/Off), backbone VLAN (Enable/Disable)
and backbone VID. Click the Restore button. Verification prompt appears.
3. Click Yes to confirm.
4. Restart the device, either through the Remote reset option or through the LCS
Init software. The new settings are applied after Reset.
Temperature: 0°C - 90°C
Low voltage minimal value: 3100
High voltage maximal value: 3500
SUMMARY
2
- FTTO Init.
2
- FTTO
Page 35 of 87
Advertisement
Table of Contents
