Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
7 7 U p d a t i n g F i r m w a r e V e r s i o n s
U p d a t i n g F i r m w a r e V e r s i o n s
7.1
General
The manageable Mosaic switch firmware comprises three elements, each updated separately:
Image – SNMP Agent software
•
Content – Java Applet (Web management interface)
•
Configuration – Configuration file
•
The firmware may be updated as follows:
Locally (CLI) through a serial connection (Section 7.2)
•
Via the LCS
•
without the CLI cable
Remotely through the Embedded web interface Remote Firmware Update
•
7.2
Local (CLI) Firmware Update
Update the firmware locally through a serial connection as follows:
1. Launch a terminal emulation application.
2. Connect the CLI serial cable to the manageable Mosaic switch switch.
3. Modify the SNMP Get / Set Community parameters (if necessary).
4. Update the IP address of the TFTP server that will be used to download new TFTP
software versions to the device.
5. Update the TFTP filename of the new software version to be downloaded to the device.
6. The prompt Boot operation [1: Download image, 2: Download content, 3: Run] appears,
enabling to download a file to the device or to continue.
Enter 1: Download image to download / update the SNMP agent of the
manageable Mosaic switch file with a .bin extension (for example: w56x_290_01.bin).
Enter 2: Download content to download / update the Web management applet of the
manageable Mosaic switch file with a .con extension (for example: w5xx_282.con).
NOTE: Since each file downloads separately, after downloading one file, repeat steps 5
and 6 in order to download the other file.
7. After downloading / updating the image and content files (this may take a few minutes)
the user is prompted to enter new boot parameters. Enter new parameters or press
Enter to accept the existing parameters. At the Boot operation prompt, chose 3: Run in
order to reboot the system with the updated files.
Now the unit restarts operations according to the updated files and parameters.
2
- FTTO Init Remote Device Configuration application for devices supplied
SUMMARY
Page 74 of 87
Advertisement
Table of Contents
