Manageable Mosaic switch Installation and User Guide
approximately 60 seconds. To resume the Telnet session you must re-connect and log in again.
To redirect a Legrand manageable device to check management access passwords locally rather than
via the Radius server:
Type the Telnet command set http password followed by any of the user level access words
•
(tech, admin, or guest) and then the new password (****) you want to assign to that user level.
This will change the password for that particular user level, as well as restore the last passwords
assigned to the other two user levels (see Section 0).
8.5 Changing MAC Security via Telnet
The following Telnet commands are used to set MAC security parameters:
•
set http password radius
settings
set http password radius mac
•
local MAC address is listed on the Radius Server
Use the following Telnet commands to return to the default settings:
•
set http password Technician tech
•
set http password Admin admin
— The login password is determined by Radius server
— The Radius server checks that the approved
SUMMARY
Page 85 of 87