Manageable Mosaic switch Installation and User Guide
Figure 3-27 RSTP Ports Configuration tab
Priority: Priority of the port for the spanning tree algorithm. A lower number is
•
regarded as higher priority. Enter a value between 16 – 240, in increments of 16.
Enable: Activate or deactivate (Check/No Check) the port to participate in the
•
spanning tree algorithm.
Path Cost: Cost of the port for spanning tree algorithm. The lower number is regarded
•
as a better path. Enter a value between 1 – 268,435,455.
After network stabilization the following read only fields are updated according to the RSTP results:
State: The current state of the port as a spanning tree member port.
•
Oper Edge: Detects whether the port is an edge port (usually connected to a user
•
host/device) or a network port. A network port will receive BPDU frames whereas an
edge port will never receive BPDU frames.
Click Apply to activate and save the RSTP settings.
•
Note: When Apply is clicked, the system checks the validity of the parameters. An error
window, indicating the correct range, appears in case of incorrect parameter settings.
3.6.8 IGMP
To configure IGMP
Click on the Features icon and select the from the Features menu the IGMP Snooping
•
Configuration tab.
Configure Status (Enable, Disable), Join and leave Messages
•
Click IGMP Snooping Discovered Configuration to get a table view of the IGMP
• •
Snooping discovered Ports Configuration
SUMMARY
Page 44 of 87