Selecting The Static Ip Address Of The Device - LEGRAND Mosaic Manageable switch Installation And Configuration Manual

Manageable Mosaic switch Installation and User Guide
Figure 8-1 Telnet Commands
IS 2> set port ?
Usage:
set port port_num on|off|10|100|hdx|fdx|an|man
set port port_num flowcontrol on|off
set port port_num egtagins|egtagrem|ingtagrem on|off
set port port_num vlanfilter|egdoubletag on|off
set port port_num name new_name
set port port_num vid default_vid
Examples:
set port 2 fdx - change port 2 duplex mode to full-duplex
set port 1 egtagrem on - enable VLAN tag removal on port 1 egress
set port 2 egdoubletag on - enable double tagging on port 2 egress
set port 4 name Greg_laptop - change port 4 name to Greg_laptop
set port 3 vid 1160 - change default VID of port 3 to 1160
Figure 8-2 Telnet Help on specific command

8.3 Selecting the static IP address of the device

The static IP address used to manage the device cannot be updated using the web interface. In order to
perform this configuration change, it is necessary to connect to the device using telnet. For more
information about how to connect to the CLI using telnet, please refer to "6.2 Run Telnet" Once
connected to the CLI, you can select the IP parameters of the device by using the following command:
set ip params <ip_address> <netmask> <default_gw>
Once the configuration has been changed, it will be effective after the next reboot
SUMMARY
Page 83 of 87