Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
Figure 5-1 Management menu, Access List tab
2. Click Add, type the IP address of the remote manager's workstation from which access
will be allowed in the new window and click OK. Repeat for each additional IP address
to be added (up to eight).
3. Verify that the IP address of the active manager (issuing the command) is on the
Access List.
4. From the Enable/Disable list, select Enable.
5. Click Apply and then click Yes in the verification window.
To delete an address select the address from the list and click Delete.
5.1.4 Management Interfaces
Factory defaults configure all three management interfaces (SNMP, Web and Telnet) to be active. This
configuration can be changed so that the device can only be managed by one or a combination of two
management interfaces. To configure the management interfaces proceed as follows:
1. From the Management menu click the Management Interfaces tab to make a
selection from the Services field drop down list.
2. Click Apply
Figure 5-2 Changing Management Interfaces-Services
SUMMARY
Page 59 of 87
Advertisement
Table of Contents
